MTD 19940 Snow Blower Manual

The MTD 19940 Snow Blower is a powerful machine designed to efficiently clear snow from driveways and sidewalks. It features a 21-inch clearing width, a 179cc engine, and a 2-stage snow throwing system that can handle heavy snowfalls. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Safety Information 3. Operation Instructions 4. Maintenance 5. Troubleshooting

Features at a Glance

Key components: 21-inch clearing width, 179cc engine, 2-stage snow throwing system, adjustable chute, and ergonomic controls.

Feature	Description
Clearing Width	21 inches for efficient snow removal
Engine	179cc for powerful performance
2-Stage System	Throws snow up to 30 feet
Adjustable Chute	Directs snow where needed
Ergonomic Controls	Easy to operate and maneuver

Safety Information

Always read the safety instructions before operating the snow blower. Wear appropriate clothing and safety gear. Keep hands and feet away from moving parts.

Inspect the area for obstacles before use.
Never operate in enclosed spaces.
Do not overload the machine.
Shut off the engine before clearing blockages.

WARNING! Failure to follow safety instructions may result in injury.

Operation Instructions

To operate the MTD 19940 Snow Blower, follow these steps:

Start the engine using the recoil starter.
Adjust the throttle to the desired speed.
Use the drive control to move forward or backward.
Direct the chute using the control lever.

CAUTION! Ensure the area is clear of people and pets before starting.

Maintenance

Check oil level: Regularly inspect and change oil as needed.
Inspect belts: Ensure belts are in good condition and properly adjusted.
Clean the machine: Remove snow and debris after each use.
Store properly: Keep in a dry place when not in use.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Fuel issue	Check fuel level and quality.
Snow not throwing	Clogged chute	Clear any blockages in the chute.
Unusual noise	Loose parts	Inspect and tighten any loose components.
Machine vibrates excessively	Imbalanced blades	Check and balance the blades.

Reset: Refer to the manual for reset procedures if available.

Service: Contact customer support for further assistance.